Web Serial Terminal: Connection Guide and Troubleshooting
Connect to a serial device from your browser, inspect received bytes in HEX or an ANSI terminal, and send text or hexadecimal commands. Serial communication takes place on your computer without a local terminal server.
Browser and Device Requirements
Use a desktop browser with Web Serial enabled, such as Chrome or Edge, over HTTPS or localhost. Browser policies and operating-system permissions can restrict access. The page detects API availability; a browser name alone does not guarantee access.
Connect a device that exposes a serial port, using a data-capable USB cable. USB-to-serial adapters may require an operating-system driver. Close other serial monitors before opening the same port.
How to Connect a Serial Device
- Connect the device and select its documented baud rate, data bits, stop bits and parity.
- Select Connect and choose the correct port in the browser permission dialog.
- Choose the terminal or HEX display and inspect incoming data.
- Choose text or HEX sending, set the line ending required by the device, and send a known command.
- Disconnect before opening the device in a firmware flasher or another terminal.
ASCII, HEX and Line Endings
Text and HEX are different representations of bytes. For example, sending the byte 41 in HEX represents ASCII A; sending the text 41 sends the two characters 4 and 1. Binary protocols are usually easier to inspect in the HEX view.
A device may wait for LF, CR, or CRLF before processing a text command. Select the protocol’s expected ending instead of assuming Enter is sufficient. DTR and RTS can affect reset or boot mode on some boards; use them according to the board documentation.
Troubleshooting Serial Connections
No port available: check the USB cable, system device list, adapter driver and browser permissions. A charge-only cable will not provide a data connection.
Port fails to open: close IDE serial monitors, other browser tabs and native terminal programs, then retry. Check operating-system access permissions.
Unreadable text: verify baud rate and framing parameters. Binary traffic is not necessarily readable text; inspect it in HEX.
No response: check the command bytes, line ending and device protocol. For UART adapters, verify TX/RX wiring, a common ground and compatible logic voltage using the device documentation.
Frequently Asked Questions
Can this terminal flash ESP firmware?
It sends and receives serial data but does not implement the ESP flashing workflow. Disconnect here and use the ESP Firmware Flasher for that task.
Can two tools use the same serial port at once?
An open serial port is normally exclusive. Disconnect the current tool before connecting with another tab, IDE or flasher.
Is received serial data sent to a server?
The terminal reads and writes the selected port locally. Its communication code does not forward terminal data to a processing server. The website also loads analytics and advertising scripts.